![]() In the case of a problem with the circuit board, you need to replace the entire keyboard, including the circuit board, to fix the problem. If the key still doesn't work after putting it back on or replacing the keycap, key pad, or key retainer, the circuit board for the keyboard may not be working. Key still doesn't work after fixing or replacing Be mindful that it is properly oriented over the retainers, and push down to snap it back into place. Once this bar is removed, place the new spacebar on the laptop. Before placing the spacebar keycap back onto the laptop, a bar (shown below) must be removed by inserting your flathead screwdriver beneath it and gently pulling upward. The image below shows the spacebar removed from a laptop. Unlike the other keys on the keyboard, the spacebar requires additional steps to get it back on properly. Once snapped in, test the key and see if it works again. If the key does not look right, try pressing down on all corners of the key to make sure all clips are snapped into place. ![]() Once the above two steps are completed, position the key cap over the retainer in the proper orientation and press down lightly.These metal hooks help determine the orientation of the key retainer laid into them, as the retainer should align with the hooks. If you're not sure what direction the laptop key retainer goes, check the orientation of the metal hooks on the base of the keyboard.
0 Comments
Leave a Reply. |